Robotics bearings • linkages • assemblies

Request a Quote

Request a catalogue bearing, miniature linkage or drawing-defined joint assembly. Start with a part number, a drawing reference or a short description; technical details can follow.

For a catalogue bearing or linkage

  • Full model or designation, including suffixes
  • Quantity and delivery destination
  • Required timing
  • Drawing, datasheet or documentation requirements

For a robotic joint or assembly

Name the robot joint or connection and provide End A / End B interfaces, centre distance, movement and load cases. Include the drawing revision, clearance or starting-torque targets with test conditions, and prototype or production quantities. Mark undefined values as unknown.

A listed model can be your starting point; a modified component or complete assembly requires its own drawing and review. Compare linkage options · Check the engineering information

Tell us what you need

Choose “I know the part number” for a catalogue model, or “I need a custom part or assembly” for a drawing-defined component. Use “I have dimensions or an application” when the model is unknown. Send drawings by email using the same part or project reference.

Read our Privacy Policy for details about enquiry records and contact channels.

SphAxis Guided RFQ - Review Draft v2

Your starting point

Fields marked with an asterisk are required. Share what you know; undefined technical values can follow.

A full part number, a drawing reference or a brief description is enough to start. You do not need all three. Keep every suffix and include units for any dimensions.
For example: installation dimensions must stay fixed; the current part wears out or cannot be relubricated.

Quantity and supporting information

An estimated quantity or “not yet defined” is welcome.

Optional; prototype enquiries are welcome without an annual estimate.
You can send supporting files by email after this enquiry. Contact us before sharing restricted drawings.
State any drawing, inspection report, traceability or customer document requirements. Availability and scope are confirmed during review.
This section is optional. A drawing may already contain the installation details.

Dimensions and installation

Choose a product type above to see relevant dimension fields. Include units with your values; leave unknown values empty.

Include the unit, such as mm or inches, or use the dimension unit selected above. Leave empty if unknown.
Include the unit, such as mm or inches, or use the dimension unit selected above. Leave empty if unknown.
Include the unit, such as mm or inches, or use the dimension unit selected above. Leave empty if unknown.
Include the unit, such as mm or inches, or use the dimension unit selected above. Leave empty if unknown.
Include the unit, such as mm or inches, or use the dimension unit selected above. Leave empty if unknown.
Include the unit, such as mm or inches, or use the dimension unit selected above. Leave empty if unknown.
Describe mounting points, overall length, offsets or dimensions that cannot change.

Application and operating conditions

Describe actual working conditions. Do not enter catalogue load ratings as application loads. A dimensional match alone does not confirm suitability.

For swinging motion, write ±15° or 30° total travel. Keep installation misalignment separate.
Include the unit, such as cycles/min or rpm, and duty cycle if known.
Include units such as N or kN, and note any shock or reversing load. Enter application loads, not catalogue load ratings.
Include °C or °F and the expected range, if known.
Include hours, cycles or the applicable test conditions, if specified.
Leave open if you need a recommendation.
If specified, include target values, units and measurement conditions. For assemblies, state whether the target applies to a bearing or the complete assembly.

Contact details

Company and phone details are optional. A personal email address is accepted.

Optional. Include the country code if you would like us to use this number.

About your enquiry data

SphAxis uses the contact, purchasing and technical information you provide to review and respond to this enquiry. Submissions are stored in this website’s WordPress database and used to generate an email notification for [email protected]. A record may also include your IP address, browser, device type and source page.

Email supporting files to [email protected]. Include your name and part or project reference. Contact us before sharing restricted drawings or if confidentiality arrangements are required. Read the privacy policy.

A quotation, technical suitability, stock and delivery timing require separate confirmation.